Introduction

This guide is for the Euhomy IM-06D icemaker. This guides purpose is to replace the digital display. This part controls the lights and controls of the icemaker on the top of the cover. Some symptoms of this would be the lights for the buttons not turning on or them no longer working. Please make sure to unplug the device before starting all guides.

What you need

Step 1 Lid

Euhomy IM-06D Digital Display Replacment, Lid: step 1, image 1 of 3

Euhomy IM-06D Digital Display Replacment, Lid: step 1, image 2 of 3

Euhomy IM-06D Digital Display Replacment, Lid: step 1, image 3 of 3

Open the lid.
Remove the two 5 mm Phillips screws that secure the lid.
Gently lift the lid off, with care not to damage or strain the attached cable.

Edit

Step 2

Use a jimmy to pop off the white cover on the back of the lid.

Edit

Step 3

Euhomy IM-06D Digital Display Replacment: step 3, image 3 of 3

Remove the two 5 mm Phillips screws that secure the display PCB.
Remove the lid.

Edit

Step 4 Digital Display Replacment

Euhomy IM-06D Digital Display Replacment, Digital Display Replacment: step 4, image 1 of 2

Euhomy IM-06D Digital Display Replacment, Digital Display Replacment: step 4, image 2 of 2

Disconnect the display connector.

Edit

Conclusion

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.