Eton FRX3 Dynamo Unit Replacement

You're viewing a previously published version of this guide. View latest version

Feb 01, 2017 - 06:41:39

Feb 01, 2017 - 08:52:07 Feb 01, 2017 - 08:46:00 Feb 01, 2017 - 06:44:52 Feb 01, 2017 - 06:41:39 Feb 01, 2017 - 06:41:32 Feb 01, 2017 - 06:39:59 Feb 01, 2017 - 06:39:39 Feb 01, 2017 - 06:32:22 Oct 17, 2016 - 01:26:48 May 10, 2016 - 03:59:28 May 10, 2016 - 03:58:59 May 10, 2016 - 03:58:35 Mar 30, 2016 - 01:08:30 Mar 30, 2016 - 01:07:55 Mar 30, 2016 - 01:04:32 Mar 28, 2016 - 01:05:30 Mar 26, 2016 - 02:54:57 Mar 26, 2016 - 02:10:24 Mar 26, 2016 - 02:10:16 Mar 26, 2016 - 12:13:55 Mar 26, 2016 - 12:02:25 Mar 23, 2016 - 01:14:09 Mar 23, 2016 - 12:58:58 Mar 23, 2016 - 12:51:01 Mar 23, 2016 - 12:50:52 Mar 23, 2016 - 12:50:48 Mar 23, 2016 - 12:50:33 Mar 23, 2016 - 12:50:23 Mar 23, 2016 - 12:50:10 Mar 23, 2016 - 12:49:40 Mar 23, 2016 - 12:46:16

Newer

Introduction

If the hand crank of the Eton FRX3 isn't working, the dynamo unit may have worn, stripped or ceased gears and will need to be replaced.

What you need

Step 1 Tuning Dial

Eton FRX3 Dynamo Unit Replacement, Tuning Dial: step 1, image 1 of 1

Unplug the socket connection from the motherboard as shown in the image.

Step 2

Remove the two 1 cm Phillips #0 screws that secure the tuning dial panel to the motherboard.

Step 3

Gently lift the dial upwards to remove it.

Step 4 Motherboard Assembly

Eton FRX3 Dynamo Unit Replacement, Motherboard Assembly: step 4, image 1 of 1

Unplug all the component socket connections from the motherboard as shown in the image.

Step 5

Remove the six 1 cm Phillips #0 screws that secure the motherboard to the case.

Step 6

Fold the motherboard over the bottom of the device case.
Be careful not to damage the wires leading to the speaker.

Step 7 Dynamo Unit

Eton FRX3 Dynamo Unit Replacement, Dynamo Unit: step 7, image 1 of 1

Remove the four Philips #00 screws securing the dynamo to the case.

Step 8

Gently pull the dynamo straight upwards to remove it.
The gears on the dynamo are greasy. Try to avoid touching them to keep the new gears as much lubricated as possible!