Free Shipping on Domestic Orders $75+

Introduction

The side button array consists of the volume button, power button, M button and H button. The side button array is connected to the motherboard with a ribbon wire and to the front case with 3 screws. It is simple to remove and replace.

What you need

Step 1 Rear Panel

Ematic eGlide 4 Side Button Array Replacement, Rear Panel: step 1, image 1 of 1

Remove the 4.6mm Phillips #00 screw at the base of the device.

Edit

Ask FixBot

Step 2

Slide the rear panel away from the base parallel to the screen.

Edit

Ask FixBot

Step 3

Carefully remove the speakers from the rear panel.
Pull the speakers off of the rear panel.

Edit

Ask FixBot

Step 4 Side Button Array

Ematic eGlide 4 Side Button Array Replacement, Side Button Array: step 4, image 1 of 1

Remove the 3 Phillips #00 4.5 mm screws from the side button array.

Edit

Ask FixBot

Step 5

Slide the grey ribbon wire connector clip away from the ribbon wire port on the motherboard using the pointed tip of a spudger. This process will unclip the wire from the motherboard to release connection.
You do not need to fully disconnect the ribbon wire clip from the ribbon wire port: the clip will stay attached in a loose fit.
Remove the ribbon wire from the ribbon wire port on the motherboard.