Introduction
To access the internals of the 8BitDo Pro 2, follow these steps.
What you need
-
-
-
Using the iFixit blunt tweezers, peel back the top two corners of the sticker located inside the battery compartment.
Ask FixBot
-
-
-
Use a T6 Torx screwdriver to remove the four 5.0 mm screws from the back of the controller.
-
-
-
-
Insert the iFixit pick into the seam along the edge of the controller and slide it around to release the clips holding it together.
-
Use an iFixit tool to carefully pry around the edges of the controller.
-
Once loosened, gently separate the top and bottom of the controller.
-
-
-
Use a spudger to gently push up on alternating sides of the black plastic tab until it clicks up into its unlocked position.
-
Use tweezers to gently pull the cable out of its socket.
-
Separate the top and bottom casing of the controller.
-
-
To reassemble your device, follow these instructions in reverse order.
