Introduction
These instructions show how to replace the grinding burr for a DeLonghi cone grinder. The burr are very similar to those of Jura (and similar in construction). Unfortunately, however, the grinding ring has three flattened sides and is nowhere to be found. The cone burr from Jura fits, though. So the instructions are only of limited use, e.g. to get spare parts from a grinder with a defective motor, or if the replacement of the cone burr is already enough. Otherwise, the grinder must be replaced completely, it is not so much more expensive than the burr set (eg from Jura) itself. In the meantime, burr sets from other suppliers are being offered. Compare the spare part and make sure that the ring burr has three flattened sides (not two, as e.g. with Jura).
Also take a look at our wiki DeLonghi grinder jams.
What you need
-
-
-
If the bean hopper is still attached, it must be removed.
-
Use a pointed tool to remove the cap on the adjustment dial.
Ask FixBot
-
-
-
There is a Phillips screw underneath. Unscrew it.
-
Note the position and pull the dial upwards.
-
Pull the bean container upwards.
-
-
-
Mark the settings of the wheels with a pencil.
-
Use a spatula to loosen the two detents on the sides.
-
Pull off the red silicone seal.
-
-
-
-
Lift off the white plastic ring.
-
Turn the white ring with the ring gear counterclockwise as far as it will go.
-
The grinding ring is free and you can lift it out upwards.
-
-
-
The grinding ring can be completely removed from the plastic holder. To do this, lift the three detents to the side and push the ring out.
-
-
-
Unscrew the screw clockwise, i.e. the wrong way round.
-
When assembling, make sure that the screw with its fastening part fits exactly into the intended groove.
-
-
-
Carefully lift the grinding cone upwards.
-
Lift the driver up and out.
-
Now you can clean all parts thoroughly.
-
When reassembling, make sure that the metal balls fit into the corresponding recesses in the cone.
-
-
Work through the steps in reverse order to reassemble your device.
Cancel: I did not complete this guide.
3 other people completed this guide.
Special thanks to these translators:
100%
These translators are helping us fix the world! Want to contribute?
Start translating ›
4 Guide Comments
Hallo, ist es moeglich, den Mitnehmer aus Kunsstoff incl. der drei Huelsen als Ersatzteil zu bekommen?
danke im voraus
