Introduction

Removing the top cover of camera gives access to the LCD screen, control dial, and flash.

Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
  • Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.

Add Comment

Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
  • Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.

Add Comment

Remove the battery from inside the battery housing and set the cover aside.
  • Remove the battery from inside the battery housing and set the cover aside.

Add Comment

Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.
  • Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.

Add Comment

Remove the 6.4mm screw from the inside of the flash bezel.
  • Remove the 6.4mm screw from the inside of the flash bezel.

Add Comment

Deck the Halls
With tools and Fix Kits
Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.
  • Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.

Add Comment

Remove the 5.6mm screws behind the battery cover.
  • Remove the 5.6mm screws behind the battery cover.

Add Comment

Remove two 6.4mm screws on the latch mechanism on the right side of the camera.
  • Remove two 6.4mm screws on the latch mechanism on the right side of the camera.

Add Comment

Remove the 6.4mm screw on the top of the inside edge of the battery hole.
  • Remove the 6.4mm screw on the top of the inside edge of the battery hole.

Add Comment

Starting at the flash, carefully pull the front cover away from the camera. Starting at the flash, carefully pull the front cover away from the camera.
  • Starting at the flash, carefully pull the front cover away from the camera.

Add Comment

Remove the 4.3mm screw below the camera strap ring.
  • Remove the 4.3mm screw below the camera strap ring.

Add Comment

Remove two 4.8mm screws located on both sides of the eyepiece.
  • Remove two 4.8mm screws located on both sides of the eyepiece.

Add Comment

Pull the top cover up slowly.
  • Pull the top cover up slowly.

  • A ribbon cable is attached to the bottom of the top cover and the camera. Pull up very carefully to avoid damaging this.

Add Comment

Once you have revealed the ribbon cable, gently let the top cover hang off the front of the camera. Use the plastic opening tool to gently pull the white tabs on the ribbon cable, releasing the ribbon cable.
  • Once you have revealed the ribbon cable, gently let the top cover hang off the front of the camera. Use the plastic opening tool to gently pull the white tabs on the ribbon cable, releasing the ribbon cable.

  • If you pull the white tabs all the way out, just insert them back in to avoid losing them.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Mark

Member since: 04/20/2011

88 Reputation

5 Guides authored

Team

Cal Poly, Team 8-9, Regan Spring 2011 Member of Cal Poly, Team 8-9, Regan Spring 2011

CPSU-REGAN-S11S8G9

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 2,954