Short Circuit After replacing joystick of Xbox One controller 1914
After replacing the drifting original to K Silver TMR The Y on RS is constantly 100. After looking through the board schematic (top left TP and Mid top SW1) and testing with the multimeter apparently I have a short circuit between GND and RS-Y (Middle and Top pin)
My guess is
- Damaged board (Worst possibility)
- Bridge
- Faulty TMR
Here is some pictures of the solder, I used a wick to reduce the solder amount as much as possible to minimize bridges. Does anyone have any clue what is going on?
Is this a good question?
Score
0
