Fix Your Stuff Community Store

Free Shipping on Domestic Orders $75+

Repair information and diagrams for miter saws.

32 Questions View all

Options

I'm unable to find any information on how to repair my mastercraft com

Hello I'm trying to replace the bearings and remove the armature from my mastercraft 10 inch compound sliding miter saw. I'm unable to find any information on this. I've been able to figure out how to remove the motor housing. However, I'm unsure how to get the armature out of the casing. I'm not sure if it's supposed to pop out or if there's something else I need to detach first

Update (05/08/25)

Block Image
Block Image
Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest

Options

As long as the brushes are removed you should be able to put the gear on the armature in a soft jaw vice and either pull the body or give the body a few taps with a soft hammer or mallet. If the bearings need replaced the internal bearing might of stuck to the housing due to heat. Nothing else will be holding it in place.

Was this answer helpful?

Yes No
Score 0
Add a comment

Add your answer

Jay Wow will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 5

Past 30 Days: 11

All Time: 88