i successfully fixed my stick drift and whils assembling i found two yellow wires on both sides of the mother board cut,i assembled and tried to turn it on and it blinked yellow twice n switched off.ive not soldered the wires yet ,what are they for?
Edit,ive soldered them back,but the controller,still blinks yellow twice n turns off,it's not also detected on PC,any fix?
Is this a good question?
Rep: 1.1k
7
1
1
If you have yellow wires, it's a BDM 030 which is V3. The yellow and green wires are for the adaptive trigger motors. Red and black are for the "rumble". In order from the top down: Yellow>Green>Black>Red.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 2
Past 30 Days: 7
All Time: 34
