Rep: 3.3k
12
5
4
Dishwasher seems to run fine, but dishes aren't getting clean, soap is not completely removed from dispenser.
Action cam inside dishwasher shows middle spray arm is not turning.
Disassembled and cleaned out filters in lower part of dishwasher. No change.
Is this a good question?
Rep: 3.3k
12
5
4
Replaced circulation pump motor: No change
Finally noticed there didn't seem to be enough water in dishwasher.
Action cam confirms anemic flow during fill cycle.
But flow from inlet hose seemed fine.
Replaced fill valve. During replacement noticed teflon tape from installation was blocking inlet. I don't think the valve was bad but I left it in anyway.
Dishwasher now fills with a lot more water and middle spray arm turns as it should.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 1
All Time: 12
