Fix Your Stuff Community Store

The Linksys WRT54G was first released in December 2002. Its primary use is for sharing Ethernet connection among several computer.

2 Questions View all
Question Closed

Options

worked for only 5 minutes after I did hard reset

I have a wrt54g v7 Linksys router...the problem is after supplying the power, only power led glows and rest of the led's aren't glowing...I did hard reset several times and once it worked(it was detected properly and all Led's worked fine) but only for 5 min and then returned to its initial state where only power led glows...now hard reset is also not doin any gud ..

what about changing the firmware? will it be possible to change the firmware in this condition and will it work after changing the firmware ..

any help is appreciated

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

2 Answers

Filter by:
Most Helpful Newest Oldest

Options

You need power to flash the firmware.

Check the power adapter with a multimeter for the correct DC voltage.

If the power adapter is fine check the power jack. I'd resolder it on the mobo.

If it still doesn't worrk then you need to start tracing the power circits on the mobo.

Probably easier to pick up a used one and toss the old one.

Good luck!

Was this answer helpful?

Yes No
Score 0

1 Comment:

I have already checked d voltages...I used 12V 1Amp power adapter and when I checked on board using DMM ,it received proper 12v input and 3.3volts at the input of ic's

by

Add a comment

Options

Hi,

In this scenario i would recommend you to buy a new 4 port TP link wireless router.

As upgrading the firmware will do no good.

Good Luck.

Was this answer helpful?

Yes No
Score 0
Add a comment
View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 8

All Time: 613