Disks won't spin after replacing the laser
I just replaced the laser in an old gc, and it's moving, but the disk isn't spinning up. Not sure if that was already happening or if it's a new problem though. What can I try now?
Update: took it apart again to check for that solder ball, and now the disc spins, but the laser doesn't turn on
Is this a good question?
2 Comments
@sadmango, Did you remove the solder ball all lasers are supposed to be shipped with to make it transport safe?
by Geir Ove Andersen
no, i didn't know there was one
by just some mango