Rep: 1
1
How is it done? It has been broken and the scooter has an E2 error. The throttle assembly appears to be modular. I see replacement assemblies for sale online. I can remove the throttle button and have confirmed a broken sensor, but getting the old throttle body off has escaped me so-far. 🥴
Is this a good question?
Rep: 1
1
Remove the handle bar extension and grip by unscrewing it clockwise. Extra effort may be needed. Using a 3/32" hex key allen wrench, loosen the inset screw found on the underside of the throttle body shroud. Slide the throttle assembly off the end of the handle bar. Using a sharp knife, carefully cut through the shrink tubing protecting the wire lead terminal connections. Uncouple the terminals. Voilà!
Was this answer helpful?
Rep: 587
9
9
13
You mean off the bars? Look around the housing, should be a hole with a grub screw in it.
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 1
Past 30 Days: 11
All Time: 122
