Rep: 13
2
kenmore he5, panel lights work, drum light WILL NOT come on when door open but works with door closed. F25 code, replaced inlet and outlet thermistors, additional code P3E, it just beeps three times when you push start
Is this a good question?
Rep: 527.7k
11
400
1.5k
Hi @barouquebayou,
Don’t know the answer but according to the tech sheet : “Opening the door while in Diagnostic Test Mode may not activate the drum light. The light will come on when Start is pressed, or upon opening the door after the Diagnostic Test Mode has been cancelled”.
P3E is a code for the door switch opening test when in Diagnostic mode. Closing the door should give a 8:88 code and a beep.
I realize that you replaced the inlet thermister but did you test its connections back to the control board, you didn’t say? (see wiring diagram on p.12 for inlet thermister control board connection points P4/1 and P4/2)
Was this answer helpful?
The drum light will not come on when door is opened, out of diagnostic test mode, will test connections and report back.
We replaced the door switch just now and it works.
Past 24 Hours: 0
Past 7 Days: 1
Past 30 Days: 6
All Time: 228
4 Comments
Thermal fuse checked out okay
by barouquebayou
My apologies, this is a duplicate post.
by barouquebayou
@barouquebayou
What is the model number of the dryer?
by jayeff
Model 110.87088601
by barouquebayou