Skip to main content

Fix Your Stuff

Right to Repair

Store

Released September 16, 2016. Model 1660, 1778 Available as GSM or CDMA / 32, 128 or 256 GB / Rose gold, gold, silver, black, and jet black.

1910 Questions View all

iPhone 7 is Boot Looping after Housing Replacement

I have just replaced my iPhones housing, lcd/digitizer screen, battery, main speaker and rear camera. Before the repair, the phone would turn on and work normally (apart from the damaged parts).

I have just finished the repair and the iPhone turns on and enters into a boot loop. It is not being recognised by a usb cable and doesn’t charge either.

When I disconnect the lightning connector assembly the phone turns on and works perfectly. I have looked for damage on the connectors and ribbon cables and I couldn’t really see anything major . I have now ordered an OEM replacement.

The only damage I could see are little dents on the ribbon cable. If somebody could have a look at these photos and give me some feedback on what the problem could be, that would be amazing.

I have not yet checked under the circuit board, so could be a problem there too.

Block Image

Block Image

Block Image

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

I was able to fix the iPhone by testing the lightning cable assembly before installing it into the mainframe of the case. It fixed the problem. I believe something was being shorted.

It could possibly be looping because I didn’t have the grounding spring contact attached.

I hope this helps somebody with the same problem one day.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Food Review will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 19

All Time: 19