Hi, what about MacBook Air 11" 2012 where there is no SATA cable?
While doing the partition, it shows error like this;
Partition failed
Partition failed with the error:
Unable to write to the last block of the device.
Is this a good question?
Rep: 55
4
The drive is a custom blade drive in, I have replaced several of them using drives purchased from OWC with success.
Sometimes the board needs to be resoldered using a reflow system if replacing the drive doesn’t work which is very expensive.
I have occasionally done a ‘botch’ job by removing the board and putting it in a 150c temperature oven on a silicone mat for an hour or so but I don’t recommend it as it is very easy to destroy the board by overheating or warping if it is cooled too quickly
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 9
Past 30 Days: 17
All Time: 69
