Hi there. I replaced the digitiser on my iPad6. However, there’s a problem that part of the screen in the middle doesn’t respond to touch. See this photo of a drawing app.
Anyone seen anything like that before. I’m wondering if the digitiser has a manufacturing issue, or if I’m not not connecting things properly.
Thoughts?
Thanks.
Is this a good question?
Rep: 79
3
Re-seat the connector, if everythings connected right it’s a bad digi. Unless the connector is messed up
Was this answer helpful?
I had a similar problem, and noticed that one of the digitizer plugs came partially loose while installing the LCD screen. Pressing the plug back into place solved that issue.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 3
Past 30 Days: 15
All Time: 206
