Rep: 11
1
1
Hi I’ve just done an iPhone 7 screen replacement for the first time for my buddy and all went well it seems to be all functional but the only issue I have is a pressure mark on the right side of the display about half way Up as seen in pictures any tips or advice on why this may be happening?
Is this a good question?
Rep: 257
4
4
It’s the touch IC on the display flex cable that isn’t seated properly inside of the phone.
Same picture but i added some arrows for guidance, this IC has to be seated well onto that spot. if it’s not installed properly you will end up with pressure marks on the LCD.
Was this answer helpful?
Thanks for the advice but I don’t believe that’s the issue as when it’s loose from the phone (not flush with the housing) the mark isn’t present
I'm gonna post another picture, i'm not sure if you understood what i meant. i'm aware that the screen works fine when it's not installed flush with the housing, you have to adjust the position of the flex cable so that the IC fits well on top of the loudspeaker.
Ahhh that makes more sense will give this a try and report back thanks for the tips!
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 5
All Time: 164
