Rep: 25
3
1
Tried already 2 new LCDs, but somehow after some time touch do not work. Sometimes its work after forced reset, sometimes its gonna work itself. I do not have idea whats wrong. Seems like touch IC needs to be reballed???
Is this a good question?
Rep: 5.4k
6
11
It’s definitely the touch IC and you don’t want to reball anything. You want to replace it completely. If you have micro soldering experience then this should not be a hard repair. However, this is not a DIY repair and you’ll want to find a reputable repair service in case you dont know how to micro solder.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 41
I think i am gonna buy a new touch IC and swap them. It is do NOt to be programmed right, can i just swap them?
by Tomáš Havránek
Try reballing the IC.
by Owen Baker