Rep: 25
1
Display fell out while installing a hard drive . Pinns broken on motherboard connector and vertical sync cable broke on display side. Don’t know where wire go. Can I get a new connector and a ne sync cable? Photos attached.
Is this a good question?
Rep: 782.8k
1.1k
893
2.3k
@kennyz55 connector J9001 is a Molex 53780-8606 ''1.25mm Pitch Wire-To-Board Connector Wafer Assembly for SMT 6 Circuits Right Angle Emboss T/R
CN3 appears to be a Molex as well but you will have to measure the distance between the pins etc. You could most like find a replacement at places like mouser.com or digikey.com as well as many others.
Was this answer helpful?
Will need to buy P/N DF13A-6P-1.25H(76). It appears that the Molex part number 53780-8606 is obsolete.
I ordered the part on 5/24/20 and will try to install it and see if it works.
Was this answer helpful?
How did you get on with this as I have the same problem
Past 24 Hours: 0
Past 7 Days: 3
Past 30 Days: 7
All Time: 649
2 Comments
Did you manage to find a connector for CN3 on backlight board?
by Brett T
Hi Brett, got a spare or repair computer and swapped it.
by John