my dsi’s top lcd was inverted, so I was going to do a replacement. i took it apart, but wanted to make sure it still worked, so I turned it on, still half apart. turns out it was a loose cable, so it was fixed! I had to mess aroung with one of the other cables while fully assembling, and got it together and- nope. dead. tried everything. got any ideas?
Is this a good question?
Rep: 377
4
2
Hello
With a nds (i think it should be the same with dsi) , if wifi module isn’t correctly connected then the console is not booting. Make sure the connector is correctly fit and that you didn’t damage any pin.
good luck
Was this answer helpful?
What would I do if I did damage a pin?
Also, there is a very tiny cord at the top I had a hard time putting back in. Could that be causing it? Thank you very much!
Past 24 Hours: 0
Past 7 Days: 2
Past 30 Days: 4
All Time: 86
