Fix Your Stuff Community Store

Movies, music, multimedia in your home. Use our guides to repair home entertainment devices from surround sound A/V receivers or conventional stereo receivers to power amplifiers, preamplifier, speakers, and iPod/Bluetooth speaker systems.

4603 Questions View all

Options

Stereo system philips MCD295/12 blocked on hello after boot

Hello,

Someone gives me this stereo system but when I boot it it stays blocked on “hello” ?

I unmounted and it it is a little dusty, if I clean it, will it be enough ?

Thank you in advance

Update (10/18/2018)

Block Image

Please find a picture of the “problem”

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer

Options

@grimmgromm ➜ “HELLO” is displayed briefly. The system will switch to the last selected source. So in this case it may be possible that it can not find what it is looking for. Make sure that you have everything properly connected. See if you can still enter the setup Menu. Here are the user manual and the other one for you to check things out. Philips MCD295_UserMCD290-A4-1

Was this answer helpful?

Yes No
Score 2

1 Comment:

Hello @oldturkey03,

thank you for your answer.

Everything is properly connected and I can’t enter the setup menu with the remote.

I think the system was stored in a garage and was not protected against dust and humidity.

Maybe it’s not easily fixable :(

by

Add a comment

Add your answer

grimmgromm will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 3

All Time: 203