I just reinstalled my dishwasher after it had been stored for a few years in my unheated garage. The water inlet valve was cracked (big surprise) so I replaced it. Now when I ran a test cycle, the water is not draining from the dishwasher.
Is this a good question?
Rep: 603
4
1
HI:
Could be your drain pump is bad. But sitting for a year also the filter, grinder and area could be full of debris. Here is a great site to give you ideas on how to fix your washer, As you look for a part and click on the part picture you get a video on how to replace this part, but then you can see how the unit is put together and clean your unit out. Or replace parts not working. I am guessing a stuck flap valve also could be stuck closed.
https://www.partselect.ca/Models/GU1100X...
Good luck.
Alton
Was this answer helpful?
Turns out the drain pump motor was bad. Cleaned up the filter, grinder and flap valve. So far, so good. Thanks!
Past 24 Hours: 2
Past 7 Days: 9
Past 30 Days: 32
All Time: 2,132
