Rep: 1
1
I purchased a screen and digitizer assembly IF276-000-9 and noticed the home button housing is different. When I transferred it there was not enough room above for my connector.
Is this a good question?
Rep: 221.5k
15
290
807
Perhaps you can add a picture to your question so that we can visualize this better. Alternatively, take a look at this guide to see if everything matches up compared to what you received. I would also reach out to iFixit Support (help.ifixit.com) to see what they have to say.
Was this answer helpful?
Take a look at which guide?
Sorry about that Jack, here is the guide (and I edited the answer).
Past 24 Hours: 0
Past 7 Days: 1
Past 30 Days: 2
All Time: 61
1 Comment
I put the digitizer on top of each other. The bottom one was the original and top was the ifixit purchase. Hopefully you can see the part that extends where the home button ribbon goes.
by Jack