Skip to main content

Wireless laser printer by Samsung.

7 Questions View all

Imaging Drum reset?

I have the xpress C410W laser printer. I have a model that does not have the resistor clipped into the front of drum unit. I have a plug in board located under cover on front door. I want to reset the drum as it’s in perfect condition, I purchased resistors but have no where to put them. This board that connects to the prongs that make contact with toner cartridges does this contain the resistor for the drum too? And what can I do to reset this drum?

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

3 Answers

Resistor is located behind two square contacts on the front side of imaging unit (below contacts for every toner).

Look at photos in this review article:

https://www.digitaltrends.com/printer-re...

image:

https://icdn9.digitaltrends.com/image/sa...

Hope it helps someone.

Was this answer helpful?

Score 0
Add a comment

While the printer is switched on press the release button on the right of the printer then lower the front cover. Press and hold the Cancel button until the screen displays Resetting PC Counter prepaidgiftbalance.

Was this answer helpful?

Score 0
Add a comment

I have a plug in board located under cover on front door. I want to reset the drum as it’s in perfect condition, I purchased resistors but have no where to put them.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Ginger will be eternally grateful.
View Statistics:

Past 24 Hours: 5

Past 7 Days: 35

Past 30 Days: 145

All Time: 2,636