Fix Your Stuff Community Store

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Questions View all

Options

iPhone 6 backlight Filter fl2024..

Hi Guys..

I m a beginner.. i m learning about smd board repair.

Anybody cuold explain me, how can i verify if the filter (For Example fl2024 - iphone 6) is ok or working properly? I often see the videos on youtube, somebody check them withmultimer in continuity mode or check OHM.

I want to know :

Which is the correct way to verify them?

Can i check it without battery , without on the phone?

Thanks a lot

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer

Options

Hi, to test a filter what you need to do it get a multimeter and put it in continuity mode (This is also called diode mode I believe). All filters should have continuity through them so if you put any probe on one side of the filter and then the other probe on the other side you should hear a beep meaning that both sides of the filter receive a signal. If you don't have that beep then the filter is faulty or it's not properly connected to the pads. Hopefully, that helped

Was this answer helpful?

Yes No
Score 2

2 Comments:

And yes you don't have to plug the battery in

by

Thanks a lot TOm... :)

by

Add a comment

Add your answer

Umer Muhammad will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 861