Options

Why is my dishwasher getting an error code and not completing cycle

I have a Samsung waterwall dishwasher the other night I noticed water started leaking out the left side of the door only on the left side I opened it and it stopped I started it again and waited for it to see if it would happen again instead I got an Le error and it would not continue with the cycle it kept trying to drain water down in the motor it would fill up with water and then drain it back out and then fill it back up and drain it back up after shutting it off at the power source and resetting it I am now getting a 6 e error which comes about 5 minutes after starting it it sounds like the waterwall spray arm is being forced down the track it is very loud and I continuously get this error every time I reset the dishwasher and try to run it again

Answered! View the answer I have this problem too

Is this a good question?

Yes No

Score 0

2 Comments

@ashlgh993 do you have a complete model number for your dishwasher?

Oct 7, 2017 by oldturkey03

DW80J9945US i believe this is the complete model number.

Oct 8, 2017 by Ashleigh

Add a comment

Posted: Oct 9, 2017

Options

Hi @ashlgh993 ,

Here is a link that describes what to look for when you get leakage error codes on your model dishwasher.

Unfortunately error code 6E is not listed here but perhaps if you find the reason for the earlier LE code using the 1st link (also not listed but perhaps code LC is close enough) and then do a power cycle on the dishwasher for 10 minutes to see if this resets the error code.

(I think by "power cycle" that they may mean that you disconnect the dishwasher from the power outlet, or switch off the circuit breaker, for 10 minutes to allow any residual power that is stored in the control panel to dissipate and restore any held data information to the default value - see Tip at the bottom of the page in the 1st link above).

Hopefully this is of some help.

Was this answer helpful?

Yes No

Score 2

Add a comment

Samsung waterwall dishwasher

Why is my dishwasher getting an error code and not completing cycle

1 Answer

Add your answer