Rep: 35
2
1
Hi all!
After replacing my iphone 6 (no plus) screen, the flash stopped working. It does not work either in torch mode or in photo / video mode.
The rear camera works well.
When the torch button is pressed, the flash flashes for a few moments, as in this video (https://www.youtube.com/watch?v=KqxVgYUj...).
I recently replaced the flash but still have the same problem.
Solutions?
Thanks in advance.
Is this a good question?
Rep: 221.4k
15
289
807
If you have already tried Scott's suggestion, then your problem is on the logic board. It looks like the flash circuit enables the flash but probably limits out once the full current load is required. This could be the Strobe Driver IC (U1602) or the Strobe NTC filter Fl0817.
Regardless, this will need to be looked at by a reputable micro-solderer.
Was this answer helpful?
Thanks Minho for your interest. I have not used the flash for a year now and I almost gave up. I'm not a micro-solderer, however I can do some other proof that does not involve big risks?
I have the same problem how I can resolve? (iphone 6)
Rep: 253
3
1
try a new power flex cable after checking all of your settings. This cable contains the flash module
Was this answer helpful?
I have already tried to replace it, but I still have the same problem.
Hi. I have the same problem after I dropped it about 3m. I also replaced the cable. LED does still not work. I have the tools to do micro soldering. What do I need to replace?
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 13,409
3 Comments
your Video ( This video is unavailable.)
by Free Mobile Solution
I modified the link.
by Francesco
power button flex cable is what contains the flash module
by Scott Buell