While replacing my LCD I broke a small "gold" connector broke off the logic board and now the home buttom doesn't respond. What should I use to re-attach the "gold" piece to the logic board?
Is this a good question?
Rep: 1.9k
9
1
3
you may be able to solder it back on. I would try it with a low heat soldering iron and some flux core solder. Bottom line when working on iPods handle them slowly and carefully. There are lot's of small and fragile parts on and in them. If there is nothing to solder the contact to on the top of the board I have had luck with using a tiny drill bit to make a small hole in the PC then solder a pc. of small ga. wire through and solder/attach the contact to it and clip it flush.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 446
