Hello,
after I replaced the broken display of my PowerShot SX610 and putting the camera together again, it doesnt start anymore. Is there a hidden switch, which I have to push after the camera was open? And if yes, where is it located?
Thanks for your help and sorry for my bad english.
Regards Florian
Is this a good question?
I am having the same trouble right now
Any one with any idea?
Was this answer helpful?
Rep: 1.3k
15
4
2
Hello,
it is not easy to give an answer to this. As far as I know there are no hidden switches. If you only replaced the screen, there could be a problem with a power connector. Try disassambling the device, reassamble it again and check every single connector you opened. Are any flatcables upside down? Every flatcable pushed in place? Probably a broken cable (most times you can see this)?
Good luck, John
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 51
