Rep: 10.3k
15
29
6
Title pretty much explains it.
When i start a print, the extruder moves off the right edge of the tray and tries to print.
Ive tried doing a few different prints all with the same result.
Anyone know why this occurs and how to fix it?
Is this a good question?
Rep: 21.8k
31
57
42
Recalibrate center. That should fix it.
Was this answer helpful?
Thanks, but after some testing I found that the motherboard went bad. Once i determined that I was getting a new one, i tried something with mine and it fixed it. So we are all good now. Ill still accept your answer though.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 150
