The alert/beep that signals that the wash cycle is complete will not stop. I have unplugged the washer yet when I plug it back in the continuous beep is still going. Any idea on how to get it to stop?
Is this a good question?
Rep: 101.2k
8
172
358
@db2281 ,D Burse, You may have a stuck or shorted keypad switch/faulty control board or user interface board. Are other error codes being displayed, if so use the link below to decipher code. Run a diagnostic test to help determine fault, service manual below will tell how to enter diagnostic test mode and also has a lot of other good info. on trouble codes and repair. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 3
All Time: 148
