Fix Your Stuff Community Store

Repair guides and support for tablets produced by Lenovo including the ThinkPad tablet line.

468 Questions View all

Options

Broke the connector for digitizer on the logic board

Block Image

I was about replacing the screen (not the digitizer) on my tablet Lenovo A7600-f. Unfortunately I broke the connector on the logic board trying to remove the old digitizer connector. It is gone completely, so I can not connect the new screen. Do I have to change the whole logic board or am I able to buy a new connector and mount it on the logic board? Would be grateful for tip where to buy and how to mount the new connector if possible?

It was the first time trying to repair a phone/tablet myself so my confidence is low right now.

Answered! View the answer I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Chosen Solution

Options

If you are able to do micro soldering then you can replace the connector . Finding the connector my be an issue . You may have some luck finding it with aliexpress. You may have a better time replacing the whole board. Hope this helps

Was this answer helpful?

Yes No
Score 1
Add a comment

Add your answer

Joakim Rydström will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 169