Fix Your Stuff Community Store

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Questions View all

Options

Home Button flex cable and touch id.

I had to replace the home button flex cable that runs along the LCD shield plate due to damage from a broken screen. Home button works, but touch ID does not. Original button assembly. Only parts swapped were the LCD, home button flex and shield plate, and then the flex cable with the front camera and proximity sensor.

Any ideas on what to check? Reseated all of the connections a few times as well as resets and restores of the phone with no results. The flex cable was purchased elsewhere and not here.

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

2 Answers

Filter by:
Most Helpful Newest Oldest

Options

I would look for any damage to the home button flex, under a microscope if available. I would also try a different flex cable that runs along the shield, just in case there is a fault in the one you got.

Otherwise, it looks like you have done most other steps, rechecking the connections, and resetting the phone.

Was this answer helpful?

Yes No
Score 0
Add a comment

Options

Normally rebooting the phone will fix this. Hold power and home until the apple appears, then release. If that doesn't fix it, its more than likely damage to the flex cable attached to the home button, which I haven't found a way to fix.

Was this answer helpful?

Yes No
Score 0
Add a comment

Add your answer

harshy will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 103