Rep: 25
1
The USB port on my Edifier MP19 speaker/radio is damaged so now it won't charge. Can anyone advise on how to open it so I can inspect and either straighten the USB port of have it repaired? I cannot find any screw (even under the rubber pedestals, and I don't want to damage it.
Also cannot find any assembly manual online or on the Edifier site
Is this a good question?
Rep: 37
1
Rep: 25
1
I found this out the hard way. Luckily not too much damage.
You need to pry off the plastic piece where the buttons are. It clips on.
Then you need to remove the front speaker grill. There are two clips beneath the buttons which need to be raised, then gently pull the grill off.
There are screws beneath the grill. Remove the screws and you can then split the casing open. Beware of fine aerial wire that is soldered onto PCB and glued to casing. It could break quite easily.
Was this answer helpful?
I confirm that this works.
Thanks a lot, Julian Ewert.
Hello, even with this information I can't pry that button part. There is no space between parts I cannot insert any tool. Can somebody post any photos what parts look like when disassembled?
Hello everyone, I dropped it on the floor, something sounds inside, like a broken piece, I want to disassemble everything, can you help me? please
Was this answer helpful?
Rep: 37
1
You can see on my photos where you have clips, on that black part. You have to pry them with some flat tool, it's a bit tricky but doable.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 524
