Fix Your Stuff Community Store

The Samsung Galaxy Note II is a smartphone noted for its combination of a large display and software optimized for an integral self-storing stylus.

211 Questions View all

Options

After replaceing glass - touch doesn't work very well

Hi,

I've replaced my cracked glass on the Galaxy Note II and everything works well.

However, I can see that the glass is a bit higher than the metal body in the lower part (near the buttons) and the touch isn't working very well in these areas. If I press the glass down hard, it stays there and the touch is working fine then, but after a few minutes it rises up again and the touch doesn't work well (still works, but stutters).

I think it might be because some adhesive was left on the adhesive tape surrounding the body... or maybe while removing the glass, I pulled the LCD up too much...

Do I need to redo the whole procedure?

I even tried keeping the phone under a heavy weight throughout the night but even that didn't work.

Please help!

Amit

Answer this question I have this problem too

Is this a good question?

Yes No
Score -1
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer

Options

This is most likely due to the previous old adhesive for the old glass not being cleaned on the frame properly and/or newly applied adhesive was too thick causing the touch to be too high and not work properly unless pressed down hard.

I think you need to clean the adhesive very well on the frame then put new adhesive on again. I haven't done glass replacement on the Samsung Galaxy Note II so there may be other things you need to do to get it working reliably.

Was this answer helpful?

Yes No
Score 1

2 Comments:

Thanks for replying!

So do I need to buy a new glass? If I remove the glass and I want to put it on again, where do I get new adhesive from?

by

Add a comment

Add your answer

Amit will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 64