Rep: 25
1
I am unable to print anything from my printer. I have reinstalled and unplugged the cord. It gives me a code 5200 and to power off my printer. Any suggestions on how to resolve this problem?
Is this a good question?
Rep: 447.7k
11
365
1.4k
Hi,
Try the following:
1. Turn off the printer .
2. Press the Stop button for 2 second and hold it.
3. Press the On button, hold it and release the Stop button.
4. Press Stop button 5 times then release together, with the On button.
5. LCD display will blank and now resetting.
6. Computer will detect new hardware just ignore it.
7. Turn off the printer then turn it On.
Remove the cartridges and clean the heads after powering it back on
Was this answer helpful?
I have the same problem too, thank you!
Rep: 1
2
In either case, there is little you can do, aside from: an) expel the inkjet cartridges incidentally; b) flip around the printer; c) open the paper get out entryway; d) take a jar of compacted air (like Duster or equivalent) and give the zone two or three snappy showers; and after that e) reinstall the inkjet cartridges.
Utilize the Duster sparingly, short blasts just, with the spout augmentation pointed into the corners. I'd additionally give the paper nourish zone a decent wiping out with the Duster shower.
Was this answer helpful?
I don’t know what error code 5200 is but this is the solution to one of the most common printing problems with the model # MP480: https://www.youtube.com/watch?v=rdBsFDf6...
Was this answer helpful?
why my printer saying printer head not install
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 2
All Time: 1,148
