Rep: 13
2
Does anyone in the US carry Pozidriv #0 and #1 bits like those used in Ifixit's 54 Bit Driver Kit? The only place I found that even makes them is Narex in Czechoslovakia and this would require purchasing at least 10 of each size, i.e. it's out of the question. Thanks in advance for any help.
Is this a good question?
Rep: 782.4k
1.1k
893
2.3k
tried here http://www.kctoolco.com/wiha-pozidriv-po...?
Was this answer helpful?
Actually, initially I tried looking at Wiha tools because their System 4 (4mm hex bits) would work, if they made them. Wiha does make Pozidriv screwdriver bits, just like the one in the link to KC Tools, but not with a 4mm hex. Wiha does make a double ended Pozidriv, with a #0 & #1 on opposite ends, for their System 4 stuff. I have thought of loping off the center section and effectively making the two bits I'm after.
Rep: 57.5k
18
77
212
If you're just looking for bits. I don't have any ideas off hand. I usually go for Best screwdrivers. It's all I use, and I'm very happy with them
Was this answer helpful?
I have Pozidriv screwdrivers. I'm looking a US supplier of Pozidriv 4mm bits and can't find one.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 2
All Time: 282
2 Comments
Daniel Ziemba, take a look at these guys See if they got what you need. The other store I'd definitely check would be Mactools.com
by oldturkey03
Thanks, but I looked at both websites and couldn't find anything. I put up my post requesting help and insight because I think I looked everywhere while finding nothing practical. I do appreciate your response though. It may be best for me just to 'pack' a pair of #0 & #1 Pozidriv screwdrivers. :)
by Daniel Ziemba