Released on September 19, 2014, this 5.5" screen iPhone is the larger version of the iPhone 6.

867 Questions View all

Touch screen unresponsive when touched but 100% visible

I replaced the screen on my gold 6 plus, I decided to put a black screen on Iit and everything went well until I turned the phone on and the screen was unresponsive to touch. Before complete installation I did test the screen and it worked . The screen has light lines running down the screen please help

Answered! View the answer I have this problem too

Is this a good question?

Score 0

Comments:

Does the home button work?

by

I didn't attach the home button backing plate yet because I have a stripped screw and ordered a new plate, but the touch id was still funtioning

by

Add a comment

4 Answers

Chosen Solution

I would take the phone apart again and get it to were it worked before then re assemble slowly and with care checking when possible if it works to know when things go wrong.

Was this answer helpful?

Score 1
Add a comment
Most Helpful Answer

Sounds like the digitizer flex cable or socket on the board may be damaged. I would inspect those areas under a microscope.

Was this answer helpful?

Score 1

Comments:

Could also be a short , did you put all the insulating tape back on?

by

When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through

by

Add a comment

Your digitizer flex isnt properly plugged in most likely.

Was this answer helpful?

Score 0

Comments:

When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through

by

Add a comment

Touch input all jacked up after multiple screen replacement attempts

^Try this.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Josh B will be eternally grateful.
View Statistics:

Past 24 Hours: 2

Past 7 Days: 4

Past 30 Days: 8

All Time: 260