Rep: 93
3
3
Hey I just recently replaced my iPhone 6 screen and it seems to have a little lift right above where the volume up switch is at. The funny thing is that the phones frame is not bent in anyway and I've seen this before on other phones why does this happen and how could I make the screen sit flush ?
Is this a good question?
Rep: 1.1k
8
11
2
Defektive screen, I'm 99% sure.
Been working for a repair shop for almost two years now.. A while back we got in an entire batch of screens that did exactly that, the manafactures did a poor job glueing the glass down to the plastic frame, so when the phone gets warm the glass starts to seperate from the frame.
Sadly only thing you can do is replace the screen again or attempt at glueing down the glass yourself.
Was this answer helpful?
Rep: 12.1k
11
28
6
The side next to the power switch is aligned?
Any way you can pull the screen and post pics? I have a couple of ideas but pics would really help. Also it wouldn't hurt to pull the screen just to make sure a random screw didn't end up under the assembly.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 470
