Rep: 1
1
Hello to everyone i change the backside plastic followed the excellent the service manual that i found in this site but when i reassembly and power on i saw that the senter button dont work.
what i must do to resolve this problem?
Is this a good question?
Rep: 13
1
Alright, most likely an easy fix, pop off the LCD assembly and make sure the ribbon connector on the bottom left of the board is connected, if its loose take it off lightly blow on both end and re connect, then on the backside of the LCD behing the Centre Home button you'll see to pins that are springy make sure there parallel to eachother and not bent an they should match up to the two contacts right above where you plug in the USB connector,
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 2,536
