Student-Contributed Wiki

Student-Contributed Wiki

An awesome student from our education program made this wiki. It is not managed by iFixit staff.

Keurig K-10 Mini Plus Troubleshooting

Model K10 Mini Plus. Voltage/Wattage: 120 V/1425 Watts. Manufactured by Keurig.

The handle of Keurig is broken ¶ 

The handle is broken, cracked, or will not push down properly.

The handle needs to be replaced ¶ 

If the handle is broken or cracked, you can get a replacement for it online. You can get a replacement handle here

For steps on how to change the handle you can follow our steps here

There is water or coffee leaking from the Keurig ¶ 

Water is leaking from either top or bottom of the machine.

Water is leaking from the bottom of the Keurig ¶ 

If the K-cup holder is cracked, It may allow water to leak through it. Will need to be replaced. You can get parts here

Water is leaking from top of the Keurig ¶ 

If the K-cup holder is not damaged, the hose may be clogged. You will have to open up the top of the Keurig to check for this. If it is clogged you will need to follow the necessary steps to unclog it.

The water or Coffee is not dispensing ¶ 

Water is not flowing through the K-cup and out of the bottom.

The water overflows instead of passing through the machine and dispensing coffee ¶ 

If the water or coffee overflows around the K-cup holder instead of dispensing, then your needles may not be penetrating the K-cup or the K-cup holder may be clogged. You can view our guide here on how to replace the top needle.

The water never makes its path to the K-cup ¶ 

If the water poured into the reservoir does not drain, it will not reach the K-cup. The drain on the Keurig may be clogged.

To unclog it you can follow our technique guide here

The water or coffee is dispensing slowly ¶ 

The coffee is dispensing, but at a slower rate than when the machine was new.

The top needle may not be sufficiently penetrating the K-cup ¶ 

If water is dispensing abnormally slow, The top needle may be dole or not clean you will probably have to clean/sharpen the needles.

The hose is partially clogged ¶ 

If coffee is dispensing slowly and the top needle is not too dull, your water hose may be partially clogged.

to unclog the hose you can see our clean hose guide

The water is not heating properly ¶ 

The heating element may not be working ¶ 

The heating element may be damaged and will have to be replaced. For the replacement of the heating element please click on this link here

One Comment

Why is it that I signed up with a username and get a message that I am prohibited from viewing the guide?

janthonyartist - Reply

View Statistics:

Past 24 Hours: 4

Past 7 Days: 43

Past 30 Days: 201

All Time: 2,086