Answer to: iPhone 7 home button not working after screen replacement?does home button heat up?
Answer to: U601 RF Replacement iPhone 5 Baseband Chip IC U16XYou cannot replace this IC because it is paired to the baseband
Answer to: Restore error 9 and 14 after fixing iPhone screen. What to do?the problem is the way you reassembled the handset, have a look here at iPhonebits solution you have placed the screws in the wrong place
Answer to: The Error is nand flash media is keepout : 688 physical nand Block..I Recently had this with an iPad 3, it turned out to be the rear camera that was causing this error and draining the battery, after replacing the rear camera, its all working again, as Steve iPhones said above, its best to disconnect all flex cables and you will find it will most likely boot up, make sure your battery reads at least 3.6V or it will not boot. iPhoneBits
Answer to: Dead or blue screen after screen replacementHas your handset been repaired before? have a look at the link Blue screen 5s We have seen many like this after screen replacement. Regards Jim
Answer to: iPhone 5s - Infinite boot loop (after screen replacement)here is the problem, we have found it iphone 5s blue screen Fix the problem is to do with the screws being placed back in the wrong slot , Regards Jim
Answer to: Home Button flex brokenYou can order the iPad 4 flex cable from this site, cheap as well
The time of day that you have been active over the last 90 days. Each line on this graph is an action you performed on the site (we only count major actions, like voting and editing posts). The numbers on the bottom of the graph are the hour of the day in Mountain Standard Time.
Reputation over time
|Post was voted up||5||60|
|Post was voted down||1||-6|