Answer to: Why is my new iFixit battery only showing half capacity?Try contacting customer support, you can call or fill out a contact form here
Answer to: Why is my texting fonts huge and how can I change ittry pressing the volume down button while in a text message
Answer to: How do I replace signal antenna?Hi TK, Once you obtain your replacement antenna, you can follow this guide in order to gain access to the motherboard and USB Board, here you can see the blue signal antenna running from the USB Board up along the right side of the battery to the motherboard. Then you can simply disconnect the old one and attach the new part.
Answer to: right petalobe driver for a1369 MacBook air p4 or p5The p5 is the correct size for the case, I believe it might just be that p4 can do it but it is not a proper fit. Also that is indeed the correct size for the battery
Answer to: I cut my ribbon cable that runs to volume buttonsYes you can replace it, however the integration of the volume controls into a larger assembly makes it a bit hard. This is because you have to get under the logic board and remove the upper assembly bracket/back camera to get to the rest of the connectors. You can follow this guide to help you get to the assembly to replace it.
Answer to: Should I just replace the battery?There very well could be damaged internal components besides the battery connection. At the very least it need to be inspected for any corrosion on any metal and connectors then subsequently cleaned.
Answer to: shuts off before its doneIt's possible you have a blockage in your exhaust and it is shutting off due to overheating, that or one of the internal operation thermometers is stuck closed. Try this test | (copied from somewhere else) Disconnect the flexible exhaust vent hose behind the dryer to that it will vent directly into the laundry room instead of to the outside of the home. Position the dryer so that you can check the air temperature coming out of the exhaust air vent on the back of the dryer with an accurate thermometer. Clean the lint screen and place it back in the lint screen housing. Fill the dryer with a medium load of wet laundry (towels). Ventilate the laundry room as much as possible. Start a cycle with high heat. Check the air temperature coming out of the exhaust vent on the back of the dryer with an accurate thermometer. The dryer should heat to about 150 degrees and then cycle between 140 and 150 degrees. If the dryer runs and cycles normally while venting directly into the laundry room, then it is likely that you st...
Answer to: Replacing screen without disassembling interiorUnfortunately not as the screws that fasten the display assembly to the main body are tucked behind other components, and you would not be able to undo those without dissembling the device, as you can see from this guide.
Answer to: Will rain water cause the engine not to start?It could be because of a number of things getting wet (spark plug, carburetor, air intake), if it is not pressing that you use it soon you can either just wait for it to dry but it might be better for the mower to dissasemble it to individually dry the spark plug, air filter, fuel filter, carburetor, crankcase and combustion chamber. If you still have the user manual it should be easy enough to do.
Answer to: How can I clean my aspire E1-531 keyboardFollow the first part of this breakdown to disconnect your keyboard, then you can clean it using standard electronic maintenance techniques.
Page 1 of 2
The time of day that you have been active over the last 90 days. Each line on this graph is an action you performed on the site (we only count major actions, like voting and editing posts). The numbers on the bottom of the graph are the hour of the day in Mountain Standard Time.
Page 1 of 3
Reputation over time
|Post was voted up||9||108|
|Voted down a post||1||-2|
|Post was voted down||1||-6|