Vaughn

After changing the battery and charging assembly, I can now charge my phone with the USB port normally, but the wireless...

What I ended up doing in the end is soldering a little wire to the pad circled in the question, then bent the wire into an ‘S’ shape so it was about the height of the intact yellow things on the other pads. When I put the wireless charging coil assembly back on, I made sure to press it straight down, so the little ‘S’ wire I made would not bend to the side and contact the other pads. It was easy enough to do with a fine-tip soldering iron and needle-point tweezers. Thank you oldturkey03, you were right!