Adrian Zymeri

i got 2 iphone 6s that i bought from a person and he said to me they work fine but they don't connect to wifi nettworks. So i...

i have an iphone 6 and if you put it on the table and don't use it for about 20mins than it goes dead only way to wake it up ...

won't charge above 2-3% i changed the charging port but no luck

i got an iphone 6 and it was full unlocked i was using it for 2 years i have restored multiple times and i didn't had any pro...

when i connect the charger the screen tells that the phone is charged 100% i press the power button and goes into bootloop if...

what may be the problem here i have cleaned the motherboard and the antenas with alcool but still no service sometimes the se...

Can i use iphone 6 u2 on iphone 6s

i noticed that iphone 8/8+/X won't accept any cable exept original one so if you are thinking to restore/update your iphone 8...

i run an iphone service shop a custumer brought an iphone 6 he factory resset it by itself and now iphone got stuck on "could...

iphone 5s water damaged changed lcd still no touch changed touch connector on motherboard still no touc changed touch ic stil...

Connect the hdmi cable turn on the tv but not the ps4, Now Pres and hold power button for at least 7 secounds until system beeps twice. This worked for me so i hope it hepls you too

The problem with iphones with this error 80% of them are refourbished so in this case phones that has nand ic replaced or cpu or baseband apple noticed some brands of those ic and banned them so if you have a refourbished iphone from somewhere in china the only way to activate your iphone is to notice wich ic was replaced andreplace it again.

i heated the top of the motherboard near the battery connector with a heat gun at 350C and now is good but i know it won't last 1 day or 2 and i will have that problem again

use a hot air in the back of the iphone (not very hot) the glue under the battery will be more elastic and you can remove it without problem

the best answer to this question is NO

heat the wifi ic for 1 min and you will not have the same problem

tell your costumer to change the usb charger 90% he is using unofficial charger and 10% u2 ic is failing and overcharge the battery

go on settings/touch id and passcode and remove all fingers scaned before turn off the iphone and turn on it again and scan your finger print again on the same location settings/touch id and passcode

send a photo of your motherboard and dissconnect the wifi antena and let us know if anything is damaged on motherboard

try to make a call with headphones on and let me know if it freez again