Introduction

The following tear down provides a step by step guide to completely disassemble a Palm Tungsten E.

This teardown is not a repair guide. To repair your Tungsten E, use our service manual.

Image 1/2: Using T-5 torx driver, remove 4 back panel screws. Image 2/2: The screws are small and can be lost easily. Be sure to place them in a secure area.
  • Remove stylus and SD card.

  • Using T-5 torx driver, remove 4 back panel screws.

  • The screws are small and can be lost easily. Be sure to place them in a secure area.

Add Comment

Image 1/3: Continue by sliding the plastic opener to the right at the markers shown until the cover releases. Image 2/3: Continue by sliding the plastic opener to the right at the markers shown until the cover releases. Image 3/3: Continue by sliding the plastic opener to the right at the markers shown until the cover releases.
  • Begin to remove back cover by inserting the plastic opening tool under the usb and power input slots.

  • Continue by sliding the plastic opener to the right at the markers shown until the cover releases.

I think it's better to open from the right, not the left. The right will separate if you lever the metal back to the outside and push the plastic to the inside. The lft is more like a inge and would damage more easily.

Just my $0.02.

Yishai Sered - Reply

Image 1/2: Remove screen protector by lifting hinge out of plastic housing. Image 2/2: Remove top cover by gently pulling away from the device with plastic tool
  • Your device may not have a screen protector. If not, you do not need to complete step three. Please move on to step four.

  • Remove screen protector by lifting hinge out of plastic housing.

  • Remove top cover by gently pulling away from the device with plastic tool

Add Comment

Image 1/2: Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down. Image 2/2: Remove motherboard completely.
  • Carefully remove motherboard from the standoffs without damaging the LCD flex connector.

  • Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down.

  • Remove motherboard completely.

  • Metal washers may pop out of the device during this step

Add Comment

Image 1/3: Gently flex frame to release screen from plastic frame. Image 2/3: Lift out screen. Image 3/3: Lift out screen.
  • Remove buttons using fingers.

  • Gently flex frame to release screen from plastic frame.

  • Lift out screen.

Add Comment

Image 1/1:
  • Congratulations! You have successfully taken apart a Palm Tungsten E.

Add Comment

Kevin Hom

Member since: 01/21/2010

88 Reputation

2 Guides authored

Team

Cal Poly, Team 13-22, Maness Winter 2010 Member of Cal Poly, Team 13-22, Maness Winter 2010

CPSU-MANESS-W10S13G22

4 Members

4 Guides authored

One Comment

How does one unplug the battery?

dlcatftwin - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 12

All Time: 6,401