Skip to main content

Introduction

Tools you will need are a Phillips screwdriver in a flat head screwdriver. The video shows how to take the two pieces apart, and after that you would be looking at the motherboard. This is how it works. When we push the control, the transmitter sends a specific number of electrical pulses corresponding to that action through the air. The transmitter has its own power source, usually in the form of a 9-volt battery. Without the battery, the transmitter will not be able to send the radiowaves to the receiver.Once the RC toy receives the radio waves, the motors kick into life to cause a specific action to occur. The power source sends power to all working parts, including the motor. The transmitter enables control through radio waves and the receiver activates the motors. When we press a button on the transmitter to make the RC toy go forward or backward, a pair of electrical contacts touch. Receiver identifies signals, sends it to circuit.Circuit board translates the number of electrical pulses (signals) into action. Full-function controllers have six controls and these works through following the pulse sequences:

1. Forward: 16 pulses 
2. Reverse: 40 pulses
3. Forward left: 28 pulses 
4. Forward right: 34 pulses
5. Reverse left: 52 pulses 
6. Reverse right: 46 pulses

This teardown is not a repair guide. To repair your Rc car remote, use our service manual.

  1. Unscrew all the screws using the Phillips screwdriver.
    • Unscrew all the screws using the Phillips screwdriver.

  2. Use the flathead screwdriver to pop open the two  pieces
    • Use the flathead screwdriver to pop open the two pieces

  3. iPhone Battery Fix Kits

    Only $29.99

    Buy Now

    iPhone Battery Fix Kits

    Only $29.99

    Buy Now
  4. Take the  wire on the top of the motherboard off. Take the  wire on the top of the motherboard off.
    • Take the wire on the top of the motherboard off.

  5. All done just be careful so u don’t take the black or red wire off because you would have to Souter it back on.
    • All done just be careful so u don’t take the black or red wire off because you would have to Souter it back on.

Andrew Campos

Member since: 04/23/2019

109 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 28

Past 30 Days: 77

All Time: 83