Image 1/1:
  • Wedge between the frame and back cover with an isesamo and separate all of the retaining clips

Add Comment

Image 1/2: Image 2/2:
  • The connector slides out towards the outside of the device, and mine was pretty sticky so be careful.

Add Comment

Image 1/3: Disconnect the digi cable from the top right of the back of the device. Image 2/3: Disconnect the digi cable from the top right of the back of the device. Image 3/3: Disconnect the digi cable from the top right of the back of the device.
  • Disconnect the LCD ribbon cable from the top and bottom of the battery. It is unnecessary to peel it off of the battery.

  • Disconnect the digi cable from the top right of the back of the device.

Add Comment

Image 1/2: Disconnect the power/volume/home flex Image 2/2: Disconnect the power/volume/home flex
  • Disconnect the camera flex

  • Disconnect the power/volume/home flex

Add Comment

Image 1/1: At this point you can also lightly pull the battery away from the back of the LCD. There isn't much adhesive holding it in place.
  • Remove the 5 speaker assembly screws and pry off the assembly

  • At this point you can also lightly pull the battery away from the back of the LCD. There isn't much adhesive holding it in place.

Add Comment

Image 1/2: At this point, the only thing left should be the display assembly Image 2/2: At this point, the only thing left should be the display assembly
  • Remove the 5 motherboard screws and gently separate it from the back of the lcd.

  • At this point, the only thing left should be the display assembly

Add Comment

Image 1/2: Gently separate the LCD from the frame Image 2/2: Gently separate the LCD from the frame
  • Remove the 6 LCD screws and brackets

  • Gently separate the LCD from the frame

Add Comment

Image 1/3: Before heating the frame its a good idea to remove the camera from the frame so it's not damaged. Image 2/3: Before heating the frame its a good idea to remove the camera from the frame so it's not damaged. Image 3/3: Before heating the frame its a good idea to remove the camera from the frame so it's not damaged.
  • Use a heat gun or hot plate to separate the digitzer and glass from the frame

    • Before heating the frame its a good idea to remove the camera from the frame so it's not damaged.

Add Comment

Image 1/1:
  • Insert wisdom here.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

Auburn Store

Member since: 01/17/2016

233 Reputation

1 Guide authored

3 Comments

The screen is crack the screen is on when I hit the home button it won't work

Hilda Silva - Reply

I replaced screen and now screen won't light up

ruger32016 - Reply

How can u get the whole tablet fixed when the screen came off and everything is not their in its place any more???

Cupcake - Reply

Add Comment

View Statistics:

Past 24 Hours: 15

Past 7 Days: 60

Past 30 Days: 264

All Time: 3,008