Fix Your Stuff Community Store

Hoover LiNX Handle Teardown

Written By: Mark Nelson (and 4 other contributors)
Published: June 26, 2018
  • Comments: 2
  • Favorites: 0
  • Views: 2.5k

Hoover LiNX Handle Teardown

Written By: Mark Nelson (and 4 other contributors)
Published: June 26, 2018
  • Comments: 2
  • Favorites: 0
  • Views: 2.5k

Teardown

Introduction

This guide will show you how to teardown the handle to access the power button and motherboard.

What you need

This teardown is not a repair guide. To repair your Hoover LiNX, use our service manual.

  1. Hoover LiNX Handle Teardown, Hoover LiNX Handle Teardown: step 1, image 1 of 1

    • Remove the single 15mm Phillips #1 screw from the handle.

    Edit

  2. Hoover LiNX Handle Teardown: step 2, image 1 of 1

    • Remove the handle by pulling it up.

    Edit

  4. Hoover LiNX Handle Teardown: step 3, image 1 of 1

    • Remove two 15mm Phillips #1 screws from the handle.

    Edit

  5. Hoover LiNX Handle Teardown: step 4, image 1 of 2 Hoover LiNX Handle Teardown: step 4, image 2 of 2

    • Use a plastic opening tool to carefully pry the black cover off of the handle.

    Edit

  6. Hoover LiNX Handle Teardown: step 5, image 1 of 2 Hoover LiNX Handle Teardown: step 5, image 2 of 2

    • Remove five 15mm Phillips #1 black screws from the handle.

    Edit

  7. Hoover LiNX Handle Teardown: step 6, image 1 of 2 Hoover LiNX Handle Teardown: step 6, image 2 of 2

    • Remove the silver plastic cover using the plastic opening tool.

    Edit

Author

with 4 other contributors

Mark Nelson

Member since: 01/25/18

452 Reputation

2 Guides authored

Badges: 10

+7 more badges

Team

USF Tampa, Team S7-G4, Passmore Spring 2018 Member of USF Tampa, Team S7-G4, Passmore Spring 2018

USFT-PASSMORE-S18S7G4

4 Members

12 Guides authored

2 Comments

I have Hoover Linx cordless stick vacuum. Older but was very lightly used. Everything is clean moves freely, powers up, has suction, like new brush roller and belt. It all turns freely. But...turn the vacuum on...and the gear the brush belt goes around does not turn. Was hoping to find a more detailed disassembly. Anyone out there have to address that problem? Too bad as its a good little vacuum for small pickup stuff. I've alway used at large standard size for regular vacuuming thus it being lightly used.

Lori - Reply

OK, I found the instructions on the site here and disassembled it. The wires seem intact, nothing appeared pinched. Put it back together; I don't see that the company sells the replacement motor. I saw a few online but hate to spend 65 + Ship for a secondhand motor that may not even work.

Lori - Reply

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 8

Past 30 Days: 19

All Time: 2,521